Instructions Library
Access Your Instructions Below:
Clutch Alignment Tool
Setting the Fuel Setting on an Injection Pump
Water Manifold
012-0006-00-IH
001-0016-00 – IH Sleeve Flange Machining
WOEI-0001 – Idler Bushing
WOEI-0002 – Water Nozzle Maintenance
WOEI-0004 – Shifter Assembly
WOEI-0011 – 3 Bolt Hold Down
WOEI-0017 – Pro Fab Wiring
WOEI-0020 – Head Stud Instructions
WOEI-0022 – Steering Motor Information
WOEI-0024 – Gapless Ring Install 4.300” bore
WOEI-0025 – Drill and Tap Stock IH Exhaust Manifold for Temp Probes
WOEI-0026 – Port Match Stock IH Exhaust Manifold Ports
WOEI-0032 – Installing Crank into IH DT 466 Block
WOEI-0036 – Setting Timing marks on Fluid Dampener
WOEI-0041 – Crank Shaft Timing Gear Welding
WOEI-0045 – Head Gasket
WOEI-0047 – Rocker Shaft Setup
WOEI-0052 – New Vane Pump Reversal
WOEI-0053 – Pro Fab Transmission
WOEI-0056 – Copper Head Gasket No Machining Required For Fire Rings
WOEI-0057 – Copper Head Gasket
WOEI-0058 – Single Bolt Injector Hold Down
WOEI-0059 – 2 Bolt WOEI/Scheid Injector Hold Down
WOEI-0060 – Hollow Tube Axle Seal
WOEI-0061 – Internal Taper Lock Crank Hub IH
WOEI-0062 – External Oil System Plumbing
WOEI-0063 – Internal Oil System Plumbing
WOEI-H063 – IH DT 466 Block Drain Behind Injection Pump
WOEI-H064 – IH DT466 Block Preparation For Drilling Oil Feed to Front